L-com Operation of Amplifier LEDs Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware L-com Operation of Amplifier LEDs. L-com Operation of Amplifier LEDs User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 1
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
IP-00084 Rev. A – 10/06 Page 1/1
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: SAL[email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.
Operation of Amplifier LEDs
All HyperGain amplifiers have two LEDs visible on the enclosure.
The LED marked TX indicates that the amplifier is transmitting a signal. This LED will
flash during such operation.
The LED marked RX indicates that the amplifier is receiving a signal. This LED will
flash during such operation.
When the amplifier is transmitting and receiving signals at the same time, both LEDs
will flash.
*Note: Some amplifier models have a red TX LED for extra visibility. A flashing red LED
does not indicate a fault.
TX = Transmit LED*
RX = Receive LED
(Amplifier enclosure may vary from example shown)
Zobrazit stránku 0
1

Shrnutí obsahu

Strany 1 - Operation of Amplifier LEDs

IP-00084 Rev. A – 10/06 Page 1/1Copyright © This drawing is property of L-com Global Connectivity. All rights reserved. L-COM, INC. 45 BEECHWOOD D

Komentáře k této Příručce

Žádné komentáře